Important differentially expressed genes with log2 (fold change) greater than 1 or less than -1 denoting 2-fold up-regulated or down-regulated genes over time were considered for interpretation and are presented in Table  1. The expression of a subset of selected SBI-0206965 mw genes was validated by quantitative real-time PCR (qPCR) (see Additional file 5: Table S2). Real-time PCR qPCR was performed for 14 genes that showed significant

differential expression in the microarray analysis. Samples of 1 μg total RNA were reverse transcribed to synthesize cDNA using High Capacity cDNA Reverse Transcription kits (Applied Biosystems), according to the manufacturer instructions. qPCR was performed using the Power SYBR Green PCR Master Mix (Applied Biosystems) with an ABI PRISM 7900 HT Sequence Detection System (Applied Biosystems). The qPCR amplifications were performed as follows: 50°C for 2 min, 95°C for 10 min, followed by 40 cycles of 95°C for 15 s and 60°C for Ferrostatin-1 concentration 1 min, and a final dissociation curve analysis step from 60°C to 95°C. Two negative reverse transcription controls were used to show no reverse transcription contamination. qPCR validation was performed on four biological replicates. Publicly

available sequences of the transcripts from the NetAffyx Analysis Centre (http://​www.​affymetrix.​com/​analysis/​netaffx/​index.​affx) were analyzed to select target sequences, and the Primer3 software [83] and Primer Express 3.0 software (Applied Biosystems) were used for the design of the specific primers (Sigma). The primer sequences are listed in Additional file 5: Table S2. Raw data were acquired using the Sequence Detection System software, version 2.3 (Applied Biosystems), and gene expression levels were analyzed using the 2-δδCT method [84], as the efficiency of the qPCR amplifications for all of the genes tested was >90%. geNorm [85] (available from medgen.ugent.be/~jvdesomp/genorm) selleck chemical was used to select the most stable genes,

and out of the seven housekeeping genes tested, lpp, aroE, gapA were used as the reference genes, with their geometric mean used for normalization. The results are presented as log2 ratios between gene expression of treated and untreated cultures of four replicates, and they are presented as a comparison with the microarray data (Figure  3). Colanic acid learn more quantification Colanic acid was extracted from cultures grown and treated with colicin M as described above, and from untreated control cultures incubated under the same conditions. Colanic acid extraction and quantification was performed as described previously [86]. Briefly, for quantification, the amount of nondialyzable methylpentose ω-deoxyhexose (L-fucose), a component of colanic acid, was measured using a colorimetric reaction with authentic L-fucose (Sigma) as standard, and with concentrations ranging from 5 μg/ml to 100 μg/ml.