Using cyanoacrylate adhesive, the PS-FBG was glued to an aluminum plate with dimensions of 50 �� 50 �� 0.3 (L �� W �� H) cm3. The size of the plate was large enough that the waveform had only one envelop in the detection time interval of 80 ��s because reflected waves do not exist in this time interval.Figure 1.Schematic diagram of experimental setup. (a) Acousto-ultrasonic method was used to research the sensitivity distribution properties of a PS-FBG sensor on an aluminum plate. (b) Data were measured on 82 different dots distributed in a quarter-circle range. …The Bragg wavelength shift caused by the strain from the ultrasonic wave was demodulated by the balanced sensing technique [7].

By adjusting the wavelength of tunable laser source to the 3 dB position of the peak area of PS-FBG carefully, the balanced photo-detector can remove the DC voltage, double the AC voltage while remove the laser intensity noise which is the mainly noise source. Thus, this technique has a very low noise level, and the output electrical voltage is linearly proportional to the Bragg wavelength shift. Therefore, this technique can describe the Bragg wavelength shift correctly and precisely.Serving as a point-like ultrasonic source, a PZT ultrasonic actuator (M31, Fuji Ceramics, Fujinomiya, Japan) with a diameter of 3 mm was driven by an electrical pulse with a peak-to-peak voltage of 75 V. The input signal was a one-cycle sinusoidal wave at 400 kHz with a Hamming window, and thus the corresponding frequency range reached approximately 1 MHz to simulate AE signals with broad bandwidth.

Using a high-acoustic-impedance ultrasonic couplant, the PZT actuator was glued to 82 different excitation dots on the aluminum plate’s bottom surface. These dots were distributed from 0 to 10 cm and from 0�� to 90�� in a quarter-circle range, as shown in Figure 1b. To ensure careful observation of the waveform’s change, the distribution of the dots from 75�� to 90�� was denser than the distribution in other areas. Because the amplitudes of detected waveforms were greatly affected by the attachment condition, data were collected by repeating the measurement three times to guarantee the reliability of the experimental results.For convenient discussion, three naming rules were introduced.

Firstly, a Cartesian Drug_discovery coordinate system was established on the plate in which the phase-shifted area of the PS-FBG was set as the origin and the axial direction of the fiber was set as the Z-axis, as shown in Figure 1a. Then, the excitation dots were designatedD1a. The superscript a and the subscript l denote the angle and length between the actuator and the sensor, respectively. Finally, because of different observational phenomena present in this experiment, the excitation area can be roughly divided into three parts, marked as A, B, and C, as shown in Figure 1b.3.?Theoretical Analysis3.1.