Six replicate injections containing curcumin and piperine were an

Six replicate injections containing curcumin and piperine were analysed using the developed method within a

short period of time on the same day. The % R.S.D of peak area, assay and tailing less than 2% were set as acceptance criteria. LOD and LOQ of curcumin and piperine were estimated from the signal-to-noise ratio. Signal-to-noise ratio of three for estimating LOD and 10 for estimating LOQ were set as acceptance criteria. Linearity was evaluated at five concentration levels at 10%, 25%, 50%, 100% and 150% of the targeted assay concentration of curcumin and piperine. The linearity was then determined by least square regression analysis from the peak area against drug concentration plot. The analytical range was established by the highest and lowest concentrations of analyte where acceptable linearity, accuracy and precision were obtained. The robustness of a developed Galunisertib analytical method refers to its ability to remain unaffected by small but

deliberate change of the chromatographic condition which provides an indication of its reliability during normal usage. Assay was carried out using the developed method with slight change in the column oven temperature (30 °C & 40 °C) and pH of the mobile (2.8 & 3.2). Encapsulation efficiency of curcumin and piperine in Eudragit E 100 nanoparticles was determined by an indirect method by measuring the free curcumin and piperine in the nanosuspension. Prepared Eudragit E 100 nanosuspension was subjected to centrifugation (Remi, India) at 19,000 rpm for about 45 min Selleckchem NVP-BKM120 at −20 °C. About 1 mL of supernatant was withdrawn and mixed with 1 ml of methanol and the solution was then filtered through a 0.22 μm membrane. Six replicate injections were analysed using the developed method to estimate the curcumin and piperine. Eudragit E 100 nanosuspension

prepared using sonication has shown an average particle through size of 140 nm with a polydispersity index of 0.254 and zeta potential of 28.8 mV. Whereas, Eudragit E 100 nanosuspension prepared using mechanical stirring has shown an average particle size of 87 nm with a polydispersity index of 0.239 and zeta potential of 22 mV. Method development for the simultaneous estimation of curcumin and piperine was carried out with different columns but Luna C18 column has shown higher theoretical plate count and lesser tailing. Different ratio of mobile phase and buffer have been tried but the mixture of 0.1% v/v ortho phosphoric acid and acetonitrile at 45:55 proportions has shown adequate separation of curcumin and piperine. However, further increase or decrease in proportion of 0.1% v/v ortho phosphoric acid does not exhibit adequate separation between curcumin and piperine. Initially, 0.8 ml flow rate was used but increase in flow rate from 0.8 to 1.2 ml has shown adequate separation and high theoretical plates. Similarly, isocratic elution mode has shown better separation in comparison with gradient elution mode.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>